Ok, so i bought the griffin powermate, hooked it up, when i press the knob in, it goes through the different axis like it should but does nothing when i turn it, I am using the powermate plugin, Also i saw a few post's on the internet in other forums with people having the same issue, but there where no solutions or posts it was just them asking for help.

I updated mach3 to the latest version, and downloaded the plugin directly from the artsoft site. you would think it would work....

They make the software, they make the plugin ????

Am i missing something ? There are no settings in the plugin configure page.

Anyone have a hammer?

Its about to go back on ebay.

Its a shame because It looks really sweet on my machine.

Thats too bad Len......I was looking into getting one also ,guess I will hold off now

From what i can tell several other people are having the same problem. If i ever figure it out i will post a remedy.

Have you tried posting your questions over at the Mach 3 forum?

Dave

there are already several posts there, i didnt want to repeat the same question

Well then have you posted your questions on the Yahoo Mach forum?

Somebody has to know something as Art didn't write that plug-in for nothing......