Ok, DAVE....... not to sound like twitter or anything.....

I got a lovely image from one of you, thank-you, and
I have since refined the drawing, coded it and cut it...

Here is the result in ALUMINUM..... now if ANY OF YOU
have a good source of 60deg or 90 deg cutters in a
0.250" diameter cutter with tough points as I tend to cut
with mainly the points for carving designs. in various materials.

This one will be blown up later and put on a Paddle or a
pipe (shrunk) for some native friends of ours.

I will put the DXF in the file section along with the code also.

Bryan





enjoy all, and thanks for the oringinal picture.

Bryan,

Not sure what size tip you use but both of these places are good people.

http://www.centuriontools.com/

http://www.bitsbits.net/index.php?main_page=index&cPath=44&zenid=46ec81cd3673655d7058d63415afbefa

Dave